How to Change the Oil on a Toro® Zero Turn Mower

by

Changing the oil on a toro zero turn mower is very easy and it is also very important. If you want longevity, smooth operation and super performance of your zero turn mower then it is crucial to know how to change the oil and how to maintain it. Here we will discuss the steps we follow to change oil on our Toro mower. Let’s discuss.

Step-By-Step Guide: How To Change The Oil On Toro

Step 1: Warm Up the Engine

  • First we need to warm up the engine. Before draining the oil it is the easy step so you start the mower’s engine for five minutes. Also it helps to gather the debris settled at the bottom of the engine.

Troubleshooting Tip: Sometimes you face difficulty to start the engine then immediately check the fuel level and spark plug.

Step 2: Position the Mower for Draining

  • Slightly down the drain side of the mower to ensure that the oil drains completely.Turn off the engine and make sure the blade control switch is off.

Troubleshooting Tip:  Double check and keep the mower drain side in a proper position to drain completely.

Step 3: Change the Oil Filter

  • Using a filter wrench or hand to remove the old oil filter. After removing it, wipe with cloth if there is extra oil on the opening part. 
  • Before adding a new oil filter, apply a little bit of oil to the rubber ring of the new filter’s gasket. 
  • Then twist the new filter until it touches the engine. To tighten, twist it one more time but do not over tight.

Troubleshooting Tip: If the oil filter is hard to remove, use a filter wrench for better grip. Be careful not to damage the filter housing.

Step 4: Add New Oil

  • Clean the dipstick area and remove the dirt. Then take out the dipstick and pour the Toro engine oil. 
  • You can use cold or hot oil which is best after checking the manual or my Toro app. 
  • Now slowly pour the oil into the tube upto the right mark otherwise check the dipstick again if it needs more oil.

Troubleshooting Tip: Slowly pour the oil about 80 % into the tube If you overfill the oil, drain a small amount until it reaches the correct level.

Now you know how to change the oil on Toro zero turn mower. You can read our comprehensive buyer’s guide on zero-turn lawnmowers.

Also You may like to read our comprehensive buyers guide on Toro zero turn lawn mower.

Bottom line:

By following these simple steps, know how to change oil on Toro zero turn mower. So while pouring the oil we need some extra caution. Also you can use manuals for cold or hot oil which will take. So taking care of your mower and regularly changing oil can keep your mower maintained and offer superb performance and longevity.

FAQs:

How frequently should I change the oil on my Toro® Zero Turn Mower?

Actually it is recommended that after five hours of use you can change the oil on toro otherwise you can change it annualy or every 50 hours of use. its depend upon youe usage.

What type of oil should I use for my Toro® Zero Turn Mower?

To know which type oil is best for your mower you should use the user’s manual which guide properly or you can use my Toro app. Generally, a high-quality SAE 10W-30 oil is suitable for most Toro® Zero Turn Mowers.

Are there any special steps I should follow when changing my Toro® Zero Turn Mower oil?

Special steps are like:

  • Ensure your mower is on a flat surface 
  • Warm up engine before pour the oil 
  • Change the old filter 
  • Fill the oil to the right mark 

Following these steps you can easily change the oil on Toro zero turn mower.